Evenflo Easy Walk-Thru Manuel D'installation page 4

Installation
E
Cardboard Cover
D
5. Turn both upper adjustment bumpers
adjustment bumpers
door frame.
D
Check that the gate is still straight up and down then turn
each bumper two more full rotations or until tight.
6. Test to make sure the gate frame assembly is secure by firmly
shaking it. If it moves, it needs to be re-installed. Repeat steps
5 – 6.
Plastic Tie
BEFORE removing the CARDBOARD COVER and cutting
the PLASTIC TIE, ENSURE the gate is securely in place or
7. With your gate securely in place, remove the cardboard cover then
cut and discard the plastic tie.
D
F
G
8. Adjust both upper bumpers
latch is 1/8" (3.2 mm).
G
9. Inspect the gate door. Make sure it swings freely and latches securely.
2
and both lower
D
, as shown, until all four contact the
E
WARNING
serious injury may result.
D until the gap between the handle F and