Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Cardboard Cover
B
B
A
B
C
D
B
E
1. Measure and record the width of the opening where you will use
A
the gate.
2. If the opening width is 35" – 39" (89 – 99 cm), install extension
on the gate frame
extension
touch each other to securely install the extension.
NOTE: Extension can be installed on either side of gate.
3. Push four adjustment bumpers
or the gate extension.
NOTE: Make sure the adjustment bumpers are pushed all the way in.
D
4. Position gate
up and down (90º to the floor).
NOTE: Rubber contact pads may mark some mounting surfaces.
E
WARNING
DO NOT remove cardboard cover
(or plastic tie beneath it) at this time or serious
injury may result.
B
, as shown. Make sure the plastic caps on the
A
and the gate
B
touch each other. The plastic caps MUST
onto the corners of the gate frame
C
on floor in center of opening, making sure that it is straight
B
1
Assemble Gate
A
B
Publicité
Table des Matières
