Basic Operation - Tripp-Lite SmartPro SMART500USB Guide De L'utilisateur

200306109 OmniSmart and SmartPro USB Owner's Manual.qxd
Quick Installation
These connections are optional. Your UPS will function properly without these connections.
1 Phone Line/Network Line
Surge Suppression
(Select models only)
Your UPS has either jacks which protect against
surges over a phone or network dataline or jacks
which protect against surges on a phone line
only. See Specifications to determine which
jacks your model has.
Using telephone cords or network data cables as
appropriate, connect your wall jack to the UPS
jack marked "IN." Connect your equipment to
the UPS jack marked "OUT." Make sure the
equipment you connect to the UPS's jacks is
also protected against surges on the AC line.
USB Communications
2
Use any USB cable to connect the USB port of
your computer to the USB port of your UPS.
Download the PowerAlert UPS monitoring soft-
ware program appropriate for your operating
system from www.tripplite.com and install it on
your computer.

Basic Operation

Buttons
Use the ON/OFF button to do three things:
optional
Switch your UPS's Operating Mode: While your UPS is plugged
into a live AC outlet, press the ON/OFF button and hold it until you
hear a beep (about 2 seconds) to toggle between the following operat-
ing modes. Choose your UPS's operating mode based on the regional
guidelines in Step 3 of the Quick Installation section.
• UPS Mode: ENABLES battery backup. UPS Conditions: The UPS
charges its battery and supplies power at its receptacles when it is
receiving utility line power. If utility power fails, the UPS provides
power from its batteries. The "
Advantages: Provides battery backup during blackouts or brownouts.
4
7/14/2003 4:56 PM
NORM DELAY
1
NORM DELAY
2
" indicator light is lit. Setting
Page 4