Jet JCP-601 Instructions D'utilisation Et Manuel De Pièces page 17

MAINTENANCE AND INSPECTION INSTRUCTIONS (CONTINUED)
Components
Turn off all power and clean the cylinder head, motor, fan blades, air lines, aftercooler and tank on a monthly
basis.
Belts
Check belt tension every 3 months. Adjust belt tension to allow 3/8 inch to 1/2 inch deflection with normal thumb
pressure. Also, align belts using a straight edge against the face of the flywheel and touching the rim on both
sides of the face. The belts should be parallel to this straight edge (see Figure 11). Dimension A should be the
same as B and C to ensure proper alignment of the belts.
Slots in the bed-plate allow for sliding the motor back and forth to adjust belt tension.
Figure 11 - Top View
Storage
If compressor is to be stored for a short period of time, make sure that it is stored in a normal position and in a
cool protected area.
Maintenance Schedule
OPERATION
Check Safety Valve
Drain Tank (see Figure 8)
Check Oil Level
Clean or Change Air Filter
Check Intercooler
Clean Unit Components
Check Belt Tightness
Change Oil (see Figure 6)
Lock out and tag the power then release all pressure from the tank to prevent unexpected
movement of the unit.
A
Air Compressor
Flywheel
Straight Edge
Motor Drive
Pulley
Motor
B
Setscrew
DAILY



15
C
MONTHLY 3 MONTHS




