Teaching-In To Radio Energy-Saving Controllers - Lemona eQ-3 Mode D'emploi

You can delete the saved min./max. outdoor temperature
values by pressing and holding down the Display button
for longer than 3 seconds.

12. Teaching-in to radio energy-saving controllers

In order to enable communication between radio com-
ponents, the devices have to be taught-in to one another.
Proceed as follows to allow radio energy-saving control-
lers to be managed via a wall thermostat:
• First of all, the radio energy-saving controller must be set
to teach-in mode. For more information on this, refer to
the operating manual for the relevant device.
• The wall thermostat then needs to transmit a radio signal for
teaching-in purposes. To do this, press and hold down the OK
button on the wall thermostat for longer than 3 seconds.
"LEA" and the remaining teach-in time (starting at 30
•
seconds) appear on the display and the wall thermostat
transmits a teach-in signal.
When the radio energy-saving controller receives the
•
teach-in signal, "ECF" appears on its display.
The wall thermostat can be taught-in to as many radio
energy-saving controllers as you wish.
If there is interference in terms of radio communica-
tion, the radio energy-saving controller continues to
regulate the temperature autonomously, in accordance
with the most recent specifications made by the wall ther-
mostat.
Remote controls or window contacts that have previ-
ously been taught-in to the radio energy-saving con-
troller must be taught-in to the wall thermostat directly.
If the batteries in a radio energy-saving controller
have been replaced, it can take up to 1½ hours until
the actuator starts to receive data from the wall thermo-
stat again and switches to "ECF" mode.
28