Air Filter; Fuel Filter - MTD Yard Machines MTD1435a Manuel D'utilisation

For Parts Call 606-678-9623 or 606-561-4983 For Parts Call 606-678-9623 or 606-561-4983
MAINTENANCE AND REPAIR INSTRUCTIONS
ON
Fig. 31

AIR FILTER

CAUTION:
Dust and dirt wil be drawn into engine and
damage it. Keep the air filter clean.
1. Loosen knob (A) holding air filter cover in place,
remove the top cover by lifting it up. (Fig. 32)
2. Lift the air filter (B) out of air-box (C) (Fig. 33).
3. Clean air filter. Wash filter in clean, warm, soapy
water. Rinse in clear, cool water. Air dry completely.
NOTE: It is advisable to have a supply of spare filters.
4. Install air filter. Install engine / air filter cover. Make
sure latches (D) are hooked under slots (E) Fig. 35
and cover fit properly. Tighten the cover retaining
knob securely. (Fig. 34)
CAUTION:
turn your unit off and allow it to cool before
you clean or service it.
A
Fig. 32
B
Fig. 33
Never operate saw
without the air filter.
To avoid serious per-
sonal injury, always
C
www.mymowerparts.com www.mymowerparts.com
E

FUEL FILTER

CAUTION:
The fuel filter should be replaced after each 20
hours of use. Drain fuel tank before changing.
1. Remove the fuel tank cap.
2. Bend a piece of soft wire 8 to 10 inches long and
form a hook at one end.
3. Reach into fuel tank opening and hook fuel line.
Carefully pull the fuel line toward the opening until
you can reach it with your fingers.
NOTE: Do not pull hose completely out of tank.
4. Lift filter (A) out of tank (Fig. 36).
5. Pull filter off with a twisting motion. Discard filter.
6. Install new filter. Insert end of filter into tank opening.
Make sure filter sits in bottom corner of tank. Use a
long handle screwdriver to aid in filter placement if
necessary.
7. Fill tank with fresh fuel / oil mixture. See Oil and Fuel
Information page 9. Install fuel cap.
17
D
Fig. 34
Fig. 35
Never operate saw
without the fuel filter.
A
Fig. 36
E