To Stop Engine - MTD Yard Machines MTD1435a Manuel D'utilisation

For Parts Call 606-678-9623 or 606-561-4983 For Parts Call 606-678-9623 or 606-561-4983
IMPORTANT IDLING INFORMATION
In some cases due to operating conditions (altitude, tem-
perature etc.) your chain saw may need a slight adjust-
ment to the idle speed.
After warm up - See the User's Manual section 5-2, step
7 - If unit does not Idle after restarting 2 times, follow
these steps to adjust idle.
1. Idle adjustment access (J). (Fig. 11)
2. Using a Phillips or slotted screwdriver - turn screw
1/4 to 1/2 turn clockwise (to the right). Unit should
then idle properly. (Fig. 12)
NOTE: If chain turns while idling - turn screw back to the
left until chain stops and unit continues to idle.
Fig. 11
Fig. 12
RE-STARTING A WARM ENGINE (Less than 10
minutes since stopping)
1. Make sure the on/off switch is in the "I" position.
2. Depress the primer bulb 10 times.
3. Set the throttle latch.
4. Pull the starter rope rapidly 4 times. The engine
should start.
5. Push in the choke as far it will go.
6. Release the throttle latch.
STARTING/STOPPING INSTRUCTIONS
J
www.mymowerparts.com www.mymowerparts.com

TO STOP ENGINE

1. Release trigger and allow engine to return to idle
speed.
2. Press STOP switch down to stop engine Fig. 13.
NOTE: For emergency stopping, simply activate CHAIN
BRAKE and move STOP switch down.
Fig. 13
11