SOUNDMASTER FUR4005 Mode D'emploi page 11

INTRODUCTION
The init is designed to automatically synchronize its current time and date with radio signal
generated from DCF 77 Frankfurt, Germany.
POWER CONNECTION
Plug the AC power cord to a household outlet AC source. This unit is equipped with a battery
back up system, it requires a 3V CR2032 flat lithium battery (not included). Insert the battery in
the battery compartment, making certain that the positive and negative (+ and -) battery
terminals are attached to the corresponding terminals on the plate in the battery compartment. If
an AC power failure occurs; the clock automatically switches to the battery power supply, the
clock and time memory continue running. When the AC power resumes, the clock switches
back to AC again.
GETTING START
Plug the AC power cord to a household outlet AC source.
- The unit will display full segment for two seconds, then it will enter the normal mode.
- Display will lighten up.
- The unit will start searching RCC (RADIO CONTROLLED CLOCK) signal automatically.
- Antenna tower icon will turn on and keep displaying.
- Wave icon will start blooming and keep changing by 0.5 second interval.
- Automatically stop after 10 minutes if fail in receiving.
Note: Auto search can be stopped by pressing snooze button (8) for 3 seconds.
- Antenna tower icon and all wave icons will keep displaying.
- Antenna tower icon and all wave icons will turn off.
1. RECEPTION
- It will take 3-10 minutes to complete.
Note: For best results, place the radio controlled clock antenna (15) away from metal or
electrical objects and near a window with a clear view to the sky.
2. SETTING WITH RADIO CONTROLLED:
- Not necessary as it is automatically adjusted.
3. SETTING WITHOUT RADIO CONTROLLED MANUAL SETTING:
- Can be done when antenna tower icon is turned off by pressing SNOOZE button (8) for 3
seconds.
Display in good reception mode.
Display in poor reception mode
FUR4005 / English Instruction Manual
2