First Steps - Dörr SLR-9 Notice D'utilisation

04 | FIRST STEPS

·
Before first use, please fully charge the built-in Li-Ion battery.
·
Only charge with the supplied USB charging cable
·
Never leave the ring light unattended while charging.
Insert the Micro USB plug (08a) of the USB charging cable (08) into the Micro USB port (06) of the LED selfie ring light. Connect the
USB A plug (08b) to a USB socket on your computer. The charging process starts, and the LED charging indicator (07) lights up red.
When battery is fully charged, the LED charging indicator (07) lights up green. Remove the USB cable.
When the battery is totally empty, the charging time by PC is about 1,5 hours.
05 | OPERATION
05.1 Switching On/Off, changing the light mode
To switch on the LED selfie ring light, press the On/Off button (04) briefly. The LED selfie ring light is in light mode mixed light with
approx. 4400 K. For light mode cold light with approx. 8500 K, press the On/Off button (04) a second time. Press the On/Off button
(04) a third time to enter the light mode warm light with approx. 3500 K. To switch off the ring light, press the on/Off button (04) a
fourth time.
05.2 Dimming
The brightness can be dimmed in all 3 light modes:
Press button – (03) to reduce the brightness in 3 steps. Press button + (05) to increase the brightness in 3 steps.
05.3 SOS flashing function
To activate the SOS flashing, first press the On/Off button (04) briefly to switch on the LED selfie ring light. Then hold the On/Off
button (04) pressed for approx. 2 seconds until the SOS flashing starts.
9 doerr-foto.de