shark UV540CCO Manuel D'instructions page 9

Suction
Release Collar
c
Release suction
for easier push
and pull on high
pile carpets and
area rugs.
b
Fig. 11
TO USE:
1
Rotate the cord release to quickly release the power cord.
2
Secure the power cord in the cord hook.
= Brush Roll ON
= Bare Floor
= OFF
3 Press the On/Off switch (a) to the "I" position to vacuum
bare floors (straight suction only) or to the "II" position to
engage the motorized floor brush (for vacuuming carpets
and rugs). (Fig. 11)
IMPORTANT: The motorized brush indicator light (b)
will illuminate green when motorized floor brush is on, or
red if there is a blockage or jam. (Fig. 11) This feature is
designed to protect your Lifetime Belt that powers your
motorized floor brush. See Checking for Blockages on
5.
page 1
a
Fig. 12
4 G
ently press the floor nozzle down with your foot while you
grasp the handle and tilt it back towards you. (Fig. 12)
NOTE: The rotating brush on the motorized floor brush will
less the nozzle is flat against the floor and the
not spin un
handle is tilted back.
It may become necessary at times to adjust the
5
suction release (c) on the handle. (Fig. 11) If the
vacuum seems difficult to push or pull or if it is
lifting up area rugs, adjust the suction release
by
rotating the collar 90° counterclockwise to open
the valve. Rotate the collar clockwise to close the
valve when you need high suction and for vacuuming
floors.
E
6 mpty dust cup after vacuuming and periodically during
use when it appears
instructions.)
7 W
hen you are finished vacuuming, turn the vacuum off.
full. (See "Maintenance" section for
sharkclean.com
English
English
9