Preparation; Hints And Tips - Grundig KM 5040 Manuel D'instructions

Masquer les pouces Voir aussi pour KM 5040:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 14
OPERATION ______________________________
Caution:
Using for the irst time: Boil water without
adding cofee for at least 4 times.
Please follow the steps at the "operation"
section from 1 – 2 and 5 – 12.

Preparation

1
Remove all packaging and sticker materials
and dispose of them according to the
applicable legal regulation.
2
Before using of the appliance for irst time,
clean all parts which come into contact with
water carefully.
(See the "Cleaning and care" section).
3
Make sure that the appliance is sitting in an
upright position and on a stable, lat, clean,
dry and non-slip surface.
Operation
1
Open water tank cover
tank
min. 3 – up to the MAX marking on
G
water level display
Note
Use only clean, cold and fresh drinking water.
2
Close water tank cover
3
Open swivel ilter holder
ilter holder handle
4
Fill the desired amount of ground cofee up
to the MAX marking of the permanent ilter
. To do this, you may use the supplied
A
cofee measuring spoon
Note
As an alternative to the permanent ilter
suitable paper ilter
also be used, which can be inserted right
into the swivel ilter holder
5
Close the screw-on lid
. The arrow of the screw-on lid
L
be across from the arrow marking
"closed" on the thermal jug handle
6
Place the thermal jug
thermal jug
.
M
7
Connect the plug into the wall socket.
12 ENGLISH
and ill the water
C
.
F
.
C
by swinging the
E
out to the left.
D
O
.
A
may
.
E
of the thermal jug
H
must
H
for
I
.
K
on the support for
L
8
To turn the appliance on, press the On/Of
switch
N
it on.
– On/Of switch
and brewing process begins.
Note
The brewing process can be stopped at any
time by pressing On/Of switch
position.
The appliance is equipped with a drip-stop
located underneath the swivel ilter holder
and enables you to briely remove the thermal
jug
to pour cofee before the water has
L
inished running through the machine.
Caution
However make sure to place the thermal jug
on the support for thermal jug
L
very short time (max. 30 seconds). Otherwise
the cofee liquid from the ilter could overlow.
9
Remove thermal jug
for thermal jug
process has inished and thermal jug
illed.
10
To pour cofee, turn the screw-on lid
counter clockwise, until the arrow on the
screw-on lid
arrow marking
Note
You can keep cofee hot in the thermal jug
for up to 1 hour approximately.
11
To turn the appliance of, press the On/Of
switch
N
– On/Of switch
, a
appliance turns of.
12
Disconnect the appliance from the wall
socket.
Note
If you want to continue the brewing process,
repeat the procedure from 1 to 12. Let the
appliance cool down between each brewing
process.

Hints and Tips

Use softened or iltered water to prevent lime
build-up.
to the "I" position, in order to turn
indicator light illuminates
N
from the support
L
, as soon as the brewing
M
is located across from the
H
for "open".
J
to the "O" position.
indicator light and
N
to "O"
N
B
E
within a
M
is
L
H
,
L

Publicité

Table des Matières
loading

Table des Matières