TAKING STILL PICTURES
You can take still pictures using either the viewfinder or the monitor. Both
methods are easy as all you have to do is to press the shutter button.
1
Set the mode dial to h i j k l m o r
p P and press the power switch.
• The viewfinder turns on.
To shoot using the monitor, press f to turn the monitor on.
2
Decide the composition of the picture.
3
Press the shutter button gently (halfway) to adjust the
focus.
• When the focus and exposure are locked,
the green lamp lights (focus lock).
• The AF target mark moves to the focused
position.
• The shutter speed and aperture value
automatically set by the camera are
displayed (except in M mode).
• # blinks to warn of camera movement.
Push the flash lever up to make the flash
pop up.
• When # lights after the flash has popped
up, the flash is ready to fire. The flash fires automatically when the
shutter button is pressed all the way.
4
Press the shutter button all the way (fully).
• The camera takes the picture.
• The card access lamp blinks while the picture is stored on the card.
• The available settings vary depending on the mode.
Note
F2.8
F2.8
SQ1
SQ1
1600 1200
1600 1200
#mark
AF target
mark
Green lamp
En
En 25