Cutting Table; Positioning The Cutting Table - Struers Secotom-10 Mode D'emploi

Cutting Table

Positioning the Cutting Table

Secotom-10
Instruction Manual
The Secotom-10 is fitted with a moving cutting table. Movement of
the table is controlled using the joystick on the Control Panel and
through the software, which is described in section 2. Basic
Operation. The table has several 8 mm T-slots, which are used to
secure clamping tools. This ensures that workpieces are held
securely during the cutting process. Although these clamping tools
are available as accessories, details about the table and the
clamping tools are described in this and the following sections.
Although during the cutting process the table movement is controlled
through Secotom-10's software, prior to starting the cutting process,
it is necessary to position the cutting table manually.

Use the joystick on the Control Panel to move the cutting table.

Pull the joystick towards you to move the cutting table away from
the cut-off wheel, or push the joystick away from you to move the
cutting table towards the cut-off wheel.
9