Adjusting The Height Of The Cut-Off Wheel - Struers Secotom-10 Mode D'emploi

Adjusting the Height of the
Cut-off Wheel
Secotom-10
Instruction Manual
When mounting cut-off wheels with a 12.7 mm centre hole, make sure that
the 22 mm arbour insert has been removed. Failure to do this will result in
the cut-off wheel being pressed out of shape.

Mount the cut-off wheel (using the 22mm insert if necessary) and
remount the outer flange, with the machined face towards the
inner flange.

Insert the locking pin in the hole in the inner flange.
Gently fasten the flange screw using the fork spanner 17 mm.

Lower the cooling fluid nozzles to their operating positions.
The distance between the cut-off wheel spindle and the cutting table
can be adjusted to suit the individual cut-off wheels or wear caused
during the cutting process.

Use the control on the side of the Secotom-10 (illustrated in
"Getting Acquainted with the Secotom-10") to raise and lower
cut-off wheel mounting.
IMPORTANT
Inner flange
Hole for stop pin
12.7 mm axle
Insert for wheels with
22 mm arbour hole
7