Starting The Cutting Process; During Cutting - Struers Secotom-10 Mode D'emploi

Starting the
Cutting Process

During Cutting

OptiFeed
Secotom-10
Instruction Manual

Secure the work piece on the cutting table.

Position the cutting table in the correct place.

Ensure that the cooling fluid nozzles are lowered into position.

Lower the transparent cover (the machine cannot be started
before the cover is down).
The cover cannot be lifted whilst cutting is in progress.

Using the software display, enter the CUTTING menu and
set/check the correct values.

Start the cutting process by pressing the START
The software display will appear as:
If the maximum load on the motor is reached during cutting, the feed
speed is automatically reduced to compensate. As soon as the load
decreases again, the feed speed is increased accordingly.
Note

button.
29