Chuck Mode (Accessory) - Struers Secotom-10 Mode D'emploi

Chuck Mode
(accessory)
28
Secotom-10
Instruction Manual
This parameter is only displayed when a clamping tool with rotation
is fitted on the cutting table.

Mount the clamping tool on the cutting table.

Place the plug in the socket at the rear wall inside the cutting
chamber and secure it by turning the ring.

Insert the workpiece into a specimen holder with dovetail and
mount onto the clamping tool.
For clamping tools with Rotation; when chuck mode is set to Off, the work
piece is prevented from rotating during the cutting process.

Use the Arrow buttons



Press ENTER
Arrow buttons


Press ENTER
The software set up is now complete and the cutting

process can be started.
All the value and function settings defined in the CUTTING SETUP menu
are saved in the Secotom-10's memory. Therefore, if the power to the
machine is interrupted, these values are remembered.
Note

to select "Chuck mode".

to display the popup box and use the

to change the setting:

to select the setting
Note