Audio-Technica 1800 Serie Installation Et Utilisation page 10

OM1800Ser_dual(europ).qxd:Layout 1
10
Using the Automatic Scan Function
to Set Receiver Frequency
(single-channel operation)
E
N
1/10/07 14:35 Page 10
First...
Turn the power on by moving the Power Switch to 1 (for single-channel operation). Then switch
Dual-channel Control Switch to 1 (left position).
Switch is in the "1" position.
1. Press the Set button to enter the Frequency Selection Menu mode; the word "MENU" will appear.
2. Use the Up or Down arrow to reach Scan 1, Scan 2, ... (the number of scangroups depends on
the frequency band of your system). Press the Set button once to select one of the Scan
groups. The word "SCAN1", "SCAN2", ... will flash in the LCD window.
3. Press the Up or Down arrow button to begin the scan. Press the Up arrow to scan up from
the lowest frequency in the group; press the Down arrow to scan down from the highest
frequency in the group.
4. The first available frequency will flash in the LCD window. To activate this frequency selection,
press and hold the Set button until the word "STORED" appears in the LCD window.
5. If you do not wish to use the frequency found, you may press the Up or Down arrow.
The Up arrow will scan upwards, the Down arrow will scan downwards, from the
frequency you are on.
6. To lock settings and operate unit in single-channel operation (using one transmitter),
switch Dual-channel Control Switch to Hold (centre position). The receiver will return to
normal operation, audio function will be restored and the Dual-channel Control LED
indictor will turn green.
Note: Output B is not active when Power