Initial Setup; Bluetooth Operation - Crosley Director CR2405D Manuel D'utilisation

English

Initial Setup

Essential Setup
1. Place the unit on a flat and level surface. The selected location should be
stable and free from vibration.
2. Remove the tie-wrap that is holding the tonearm.
3. Rotate the Turntable Suspension Screw clockwise until it is all the way
down. This allows the turntable to float on its shock absorbers.
Note: Before turning the power on, make sure again all the connection settings are
correct.
Stereo System Connection
RCA Jacks
 The RCA Jacks output analog line-level signals and could be connected
directly with a pair of active/powered speakers or the appropriate input of your
stereo system.
 The Red plug connects with the Right channel and the White plug connects
with the Left channel.
Note: The RCA Jacks are not designed to be connected directly to the passive/unpowered
speakers. If connected to the passive speakers, the volume level will be very low.
Aux Input Connection
You can connect an audio device to this unit and play your music through its
speakers. To do this, press the AUX button to set the unit to Aux In mode,
connect the 3.5mm auxiliary cable between your audio device and the Aux In
Jack of this unit and start playing.

Bluetooth Operation

1. Press the Bluetooth button to switch to Bluetooth mode , you will hear an
activation sound from the unit.
2. Turn on the Bluetooth feature of your audio device, search for "Crosley
CR2405D" and pair.
3. Once your device is successfully paired with the unit, you will hear a short
confirmation sound from the unit.
4. Play and stream music from your device to the unit.
Note: Bluetooth Version – 2.1
6