Table des Matières
Publicité
Installation kit - Navigation system Mark IIiL
(system with monochrome monitor and rotary press switch in centre console)
BMW 3 Series saloon E36/4, touring E36/3, coupé E36/2, convertible E36/C
These instructions apply only to left-hand vehicles prepared for BMW radio or with BMW radio installed.
For use within the BMW dealer organisation only.
Installation time: 3 hours.
Installation time can vary, depending on the vehicle's condition and equipment.
Knowledge of body electrics is required.
a
Before installation, the owner's attention should be drawn to the following points:
–
The navigation computer is installed in the glove compartment, reducing the space available for stowage
purposes.
–
The vehicle documents may have to be stowed in the stowage space in the luggage compartment or in the
stowage pocket in the door trim.
–
On vehicles with additional clock for auxiliary heater, it may be necessary to relocate the clock.
b
When routing cables or wires, ensure that the cables/wires are not kinked or damaged. Additional wires
and cables must be secured with cable ties.
If the pin terminals stated are already allocated, bridges, double crimps or parallel circuits must be established.
Item numbers refer only to the overview and to the texts under the respective illustration.
Subject to technical modification.
Tools and aids required
Cable lamp
Compressed air saw
Drill
Drill cassette, 1-10 mm
Torx wrench set
Allen key set
Side cutter
1/4 inch socket wrench set
Philips screwdriver set
Flat-face screwdriver
File set
Fabric adhesive tape
c
15
Publicité
Chapitres
Table des Matières
