Cleaning And Maintenance - Redmond SkyKettle RK-M216S-E Mode D'emploi

be automatically enabled. Water is not re-boiled. At the end of the process, the appliance
switches to the standby mode.
To enable the Keep Warm mode during boiling, select the necessary temperature using
(the indicator will come on next to the selected value). To disable the mode during
boiling, press , until the temperature indication goes off.
Disabling audible signals
To disable and re-enable audible signals in the standby mode, press and hold down for
several seconds.
When re-enabling the audible signals the appliance will produce a beep.
Safety Systems
• The kettle is equipped with the system of auto shut-off upon boiling or removing
from the base.
• In case of water shortage the automatic overheat protection turns off the kettle.
Let the appliance cool down, thereafter it will be ready for operation.
III. CLEANING AND MAINTENANCE
Before cleaning unplug the appliance and let it cool down. Regularly wipe the kettle
housing and base with a damp cloth. Let the kettle and base dry thoroughly before use.
DO NOT immerse the appliance, its base, plug, or power cord in water or wash it under
running water!
DO NOT use a sponge or tissue with hard or abrasive surface, any chemically aggressive
substances, or any other agents which are not recommended for cleaning items that
come into contact with food.
While in operation scale deposits may form on both the heating element and the
housing inner walls of the appliance depending on water type being used. Use special
nonabrasive cleaning substances for kitchen utensils and appliances. Follow the prod-
uct application instructions. Thoroughly wash the appliance with water after cleaning
and wipe with a damp cloth.
ATTENTION! Before use the appliance, please, make sure that its electric contacts are dry.
Transportation and Storage
Before repeated operation or storage completely dry all parts of the appliance. Store the as-
sembled appliance in a dry, ventilated place away from heating appliances and direct sunlight.
During transportation and storage, do not expose the device to mechanical stress, that
may lead to damage of the device and/or violation of the package integrity.
Keep the device package away from water and other liquids..
IV. BEFORE CONTACTING SERVICE CENTRE
Problem Possible cause
The appliance does not
No power supply
switch on
There are scale deposits on
Early switch-off
the heating element
There is no water in the
Kettle switches off in a few
kettle, boil-dry protection
seconds
system has gone off
Appliance is new, the smell
Plastic smell during use is coming from protective
cover
Bluetooth function on the
mobile device is disabled
Ready for Sky app on the
Synchronization attempt
mobile device is deactivated
failed
Sync devices are too far
Operation status indicator is You should reset the set-
not on tings
The kettle does not boil or Boiling time is not set cor-
the boiling time is too long rectly
NOTE! In case any failure occur in the operation of the Ready for Sky app, it is not ob-
ligatory to apply to the service centre. Apply to REDMOND technical support service and
obtain the consultation of our specialists on error elimination and/or failure in Ready for
SkyKettle RK-M216S-E
GBR
FRA
DEU
NLD
ITA
ESP
Solution
PRT
Connect the appliance to a prop-
DNK
erly working electric socket
NOR
Descale the heating element
SWE
(see "Cleaning and Mainte-
nance")
FIN
Unplug the appliance, let it cool
LTU
down. Fill the kettle up above
MIN mark LVA
EST
The smell will disappear after
few uses
ROU
Enable Bluetooth function on HUN
the mobile device
BGR
Run the Ready for Sky app on the
HRV
mobile device
Ensure devices are located
SVK
within 15 meters from each
CZE
other
POL
Press and hold down the
button until the second beep is
RUS
produced
GRE
Adjust the boiling time in the
Ready for Sky mobile application TUR
UKR
KAZ
9