Technical Data - Meec tools 018600 Mode D'emploi

EN
Symbols
The following symbols provide guidance for
how to use your power tool. Make sure you
understand the symbols and their significance.
Read the instructions.
Wear eye and ear protection.
This product has a safety
class II rating. This means it
is fitted with extra or double
insulation.
Approved in accordance with
the relevant EU directives.
Recycle as electrical waste.

TECHNICAL DATA

Rated voltage
Power consumption
Speed, no load
Disc diameter
Spindle
Safety class
Dimensions
Weight
Cord length
Sound power level, L
Sound pressure level, L
Vibration level, a
h
Always wear ear protection.
36
230 V ~ 50 Hz
12000 rpm
Ø 125 mm
350 x 120 x 110 mm
100 dB(A), K=3 dB
wA
89.0 dB(A), K=3 dB
pA
11.54 m/s², K=1.5 m/s²
,
AG
The declared value for vibration and noise,
which has been measured by a standardised
test method, can be used to compare different
tools with each other and for a preliminary
assessment of exposure. The measurement
values have been determined in accordance
with EN 60745-2-3:2011.
WARNING!
The actual vibration and noise level when
using power tools may differ from the
specified maximum value, depending on
how the tool is used and the material. It
is therefore necessary to determine which
safety precautions are required to protect
the user, based on an estimate of exposure
in actual operating conditions (taking into
account all stages of the work cycle, e.g. the
time when the tool is switched off and when
it is idling, in addition to the start-up time).
DESCRIPTION
FIG. 1
1. Spindle lock
2. Back handle
3. Power switch lock
4. Power switch
5. Support handle
1200 W
6. Guard
7. Outer flange
M14
8. Inner flange
II
9. Gear housing
2 kg
ASSEMBLY
2 m
WARNING!
Switch off the angle grinder and pull out the
plug before assembly.