Intended Use; Technical Data; Function Of The Unit; Mains Connection - Rothenberger ROMAX AC ECO Instructions D'utilisation

After finishing the work, check the installation with appropriate testing equipment and assure,
that it is leakproof!
1.3

Intended use

The ROMAX® AC ECO is designed exclusively for the use of pressing jaws manufactured by
ROTHENBERGER or that have been declared suitable by ROTHENBERGER, for example the
products available from MAPRESS, Viega, Geberit, Uponor, etc.
The device and the press jaws are designed exclusively for crimp fittings, for which the corre-
sponding pressing jaws have been designed. Any other or additional use shall be deemed im-
proper.
ROTHENBERGER cannot accept any liability for the resultant consequences and damage, nor
for the use of pressing jaws from other manufacturers, nor for damage caused by these pressing
jaws.
Proper usage also includes compliance with the operating manual, compliance with the inspec-
tion and servicing conditions and adherence to all the relevant safety regulations.
The ROMAX® AC ECO is a handheld electric machine and must not be used for stationary ap-
plications.
This device may only be used correctly as described.
2

Technical Data

Voltage ...................................................................................
Rated power consumption ......................................................
Motor speed............................................................................
Maximum piston force .............................................................
Pressing time (according to nominal size) ...............................
Dimensions (LxWxH) ..............................................................
Weight ....................................................................................
Working range (system- dependent) .......................................
Application temperature range ................................................
Protection type ........................................................................
Protection class ......................................................................
Operating mode ......................................................................
Typical acceleration in hand-arm area ....................................
Sound pressure level (L
Sound power level (L
The noise level during operation can exceed 85 dB (A). Wear hearing protection!
Measured values determined in accordance with EN 60745-1:2010.
3

Function of the Unit

3.1

Mains connection

Connect only to single-phase alternating current and only to the mains voltage specified on the
rating plate. The machine may also be connected to sockets without an earth contact since it
complies with protection class II.
3.2 EMERGENCY STOP button
If there is any danger to personnel or the machine during the pressing process, press the
EMERGENCY STOP button immediately and release the ON switch. The valve will open and
the piston will return to its initial position.
) ......................................................
pA
) .........................................................
WA
ENGLISH
~ 230 V (110 V)
280 W
14000 min-1
32 kN
ca. 6-8 s
410x80x170 mm
ca. 5 kg
Ø 12 – 110 mm
0 – 40 °C
IP 20
II
S3
≤ 2,5 m/s2
93 dB (A) ¦ K 3 dB (A)
pA
106 dB (A) ¦ K 3 dB (A)
WA
(A)
11