Orbis VIARIS UNI Manuel De L'utilisateur page 69

Charger connected to the vehicle,
the status bar is solid white and
does not charge.
The protections of the installation
are triggered
After manual deactivation or with
RFID card the charge does not
stop.
The charger could not connect to a
WiFi network
Charge complete, but cable and
vehicle remain locked with solid
green status bar.
Exceeding maximum power
View basic charger data, set up
power and scheduled load, or
consult historical consumption, if I
don't have coverage in my garage
floor
The charger is performing an update.
Wait until the update completed.
If the charge modulation indicator is
off, the TMC100 is not properly
connected: Check connection to the
terminals, direction of current and that
the TMC100 securely fitted and
clamped in position as indicated in
the Charger Modulator section.
If the charge modulation indicator is
on ( ), the adjusted power does
not match incoming power supply.
Disconnect the charger from the
vehicle.
If it has been activated with an RFID
card, the same card must be used to
deactivate.
If the problem persists, release and
disconnect the cable.
If the Wi-Fi indicator (
flashing blue and does not pass to
solid blue, the charger has not been
correctly configured or the correct
password has not been entered.
If the Wi-Fi indicator is in solid blue it
is connected to a Wi-Fi network
without internet connection or the
security of the network is blocking it.
Preform reset:
Reset the protected device, restart
the charger to be allowed to remove
the cable from the charger socket.
The modulator hasn't worked.
Check the configuration according to
the incoming power supply.
Read the section of the instruction
manual Smart charger control via
web. (Once connected to the Wi-Fi
network with the password 12345678,
we open a web browser and write
192.168.2.1)
69
) is in