Meec tools 018279 Mode D'emploi page 55

FITTING THE CLIPS
Fit the clips that hold the throttle wire.
FIG. 9
FITTING THE CARRY STRAP
1. Fit the carry strap as shown in the figure
and adjust to make it comfortable.
FIG. 10
2. The fastener for the strap can be adjusted
for an optimal working posture.
FIG. 11
FITTING THE TRIMMER SPOOL
1. Align the holes in the flange and the
guard to each other.
2. Lock the flange with a hex key or the
equivalent and undo the nut clockwise.
FIG. 12
3. After removing the nut, release the inner
cap. Lock the flange with a screwdriver,
or equivalent. Place the trimmer spool
on the axle. Twist the trimmer spool
anticlockwise to lock it in place.
FIG. 13
4. Remove the trimmer spool by locking the
flange with a screwdriver or equivalent
and twisting the trimmer spool clockwise
to release it.
FITTING THE CLEARING BLADE
1. Undo the nut and remove the outer
flange.
FIG. 14
2. Fit the blade, the outer flange, the cap
and the nut. Make sure to fit the blade
with the direction of rotation specified on
the machine.
FIG. 15
3. Lock the flange using an hex key and
tighten the nut firmly anti-clockwise.
4. Remove the clearing blade by locking the
flange with a hex key or equivalent, lock
the nut with a ring spanner, and then take
off the blade.
INSERTING / REPLACING THE
BATTERY
1. Charge the battery as described in the
instructions for the charger.
2. Press the charged battery in the battery
holder so that it clicks in place.
FIG. 16
3. Press down the lock button and pull out
the battery.
FIG. 17
IMPORTANT:
Protect the battery terminals when the
battery is not in use. Otherwise the battery
can be short circuited, which can result in a
risk of fire and/or explosion.
USE
INTENDED USE
• The product is intended for cutting/
trimming grass, brushwood and weeds.
• The brush cutter is intended for thick grass
and twigs with a diameter of up to 2 cm.
• The trimmer head is intended for grass
and non lignified weeds beside fences,
walls, foundations, paths and round tree
trunks.
• The product must only be used for its
intended purpose and in accordance with
these instructions. All other use is
considered to be unsuitable.
The manufacturer cannot accept liability
for personal injury and/or material
damage resulting from improper use.
EN
51