Installation Requirements - ENJOYABLE WARMTH IH D Serie Manuel Du Propriétaire

Owner's manual
1. Connect the heater directly to a fuse – do not use a socket for the
3200 W model because of its high power consumption (13.9A).
2. In case a heater is broken, remove power immediately.
3. The heater may not be placed directly below a power outlet.
4. The heater surface temperature is high; it may reach between
250°C and 380°C. Therefore:
a. It must be installed at least 2.2 meters above ground.
b. It may not be touched when it's hot – danger of burning
c. Do not cover the surface.
d. Do not hang anything onto the heater.
5. Dimensional limits:
a. The distance between the back of the radiant heater and
b. No objects should be placed within 1000mm distance in
c. The side should remain clear at least 200mm from
6. Disconnect power and wait until the heater is cooled down before
cleaning the heater; usage of water is prohibited, except for using
a damp cloth.
7. Do not install the heater in areas that contain flammable or
explosive substances.
8. Users may not repair the heater themselves; in case of damage or
service requirements, please contact an authorized service center.

2.3. Installation requirements

The heater should be installed in an environment that meets the following
characteristics:
wounds!
the roof should be larger than 150mm.
front of the heater.
surrounding space.
IH-xxxx-D series infrared heater
Page 8 / 198 Version 1.3