Technical Data; Maintenance - Royal REC 1840 Mode D'emploi D'origine

Anleitung_REC_1840_SPK1__ 10.02.14 13:31 Seite 21
Whenever possible, use the claw stop as a
leverage point.
Cutting wood which is under tension
Special care is required when cutting wood which is
under tension. Wood which is under tension from
which it is released by cutting may in some cases
react completely unpredictably and uncontrollably. In
the worst case this could result in extremely severe or
even fatal injuries (Fig. 22-24).
This type of work must only be performed by persons
who have been specially trained.

7. Technical data

Mains voltage:
Power rating:
Cutter rail length:
Cutting length, max.:
Cutting speed at rated rpm:
Oil tank capacity:
Weight with cutter rail and chain:
Protection class:
Sound and vibration
Sound and vibration values were measured in
accordance with EN 60745.
L sound pressure level
pA
K uncertainty
pA
L sound power level
WA
K uncertainty
WA
Wear ear-muffs.
The impact of noise can cause damage to hearing.
Total vibration values (vector sum of three directions)
determined in accordance with EN 60745.
Handle under load
Vibration emission value a
h
K uncertainty = 1,5 m/s 2
Additional information for electric power tools
Warning!
The specified vibration value was established in
accordance with a standardized testing method. It
may change according to how the electric equipment
is used and may exceed the specified value in
exceptional circumstances.
The specified vibration value can be used to compare
the equipment with other electric power tools.
The specified vibration value can be used for initial
assessment of a harmful effect.
Keep the noise emissions and vibrations to a
minimum.
n
n
n
n
230 V ~ 50 Hz
n
1800 W
n
405 mm
n
400 mm
13,5 m/s Residual risks
Even if you use this electric power tool in
110 ml
accordance with instructions, certain residual
4,9 kg
risks cannot be rules out. The following hazards
II / ®
may arise in connection with the equipment's
construction and layout:
1. Lung damage if no suitable protective dust mask
2. Damage to hearing if no suitable ear protection is
3. Health damage caused by hand-arm vibrations if
95,4 dB(A)
2,5 dB

8. Maintenance

106,4 dB(A)
2,5 dB
8.1 Replacing the saw chain and cutter rail
The cutter rail needs to be replaced if
Proceed as described in the section "Assembly of the
cutter rail and the saw chain".
= 4,002 m/s
2
8.2 Checking the automatic chain lubrication
You should check the operation of the automatic
chain lubrication system on a regular basis in order to
guard against overheating and the associated
damage to the cutter rail and the saw chain. To do
this, point the tip of the cutter rail towards a smooth
surface (board, section of a cut tree) and allow the
chainsaw to run.
Only use appliances which are in perfect working
order.
Service and clean the appliance regularly.
Adapt your working style to suit the appliance.
Do not overload the appliance.
Have the appliance serviced whenever
necessary.
Switch the appliance off when it is not in use.
Wear protective gloves.
is used.
used.
the equipment is used over a prolonged period or
is not properly guided and maintained.
the guide groove of the cutter rail is worn;
the nose sprocket in the cutter rail is damaged or
worn.
GB
21