Changing The Remote Control Batteries - degardo TREVIA I Manuel D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Changing the remote control batteries

Change the batteries when the operating light (F3) is permanently illuminated red. Follow these
steps to do this:
1. Open the battery compartment cover on the back of the remote control.
2. Replace the two batteries (micro AAA) in the battery compartment.
3. Slide the cover back on until it clicks into position.
4. To prevent incorrect operation after replacing the batteries, wait 3 seconds before using the
equipment again.
Selecting a colour change programme
Use the programme selection button F8 (M) to select the colour change programme. Adjust the
colour change speed by pressing button F9 (S-/S+).
No.
Programme mode list
Soft light increasing then dimming
1
all colours
Soft light increasing then dimming
2
white light
Soft light increasing then dimming
3
all colours except white
Quick change between all colours
4
Quick random colour change
5
all colours
Care and maintenance
Figures D to G - Changing a bulb
Warning! Overheating and risk of fire!
Only use energy saving lamps and LED bulbs.
(Refer to the "technical data" table
for the relevant power ratings.)
TREVIA | STORUS | VARIA | ROVIO
No.
Programme mode list
Red light increasing then dimming,
6
followed by 3 flashes
Green light increasing then dimming,
7
followed by 3 flashes
Blue light increasing then dimming,
8
followed by 3 flashes
White light increasing then dimming,
9
followed by 3 flashes
Ensure the bulbs are handled correctly. Only use energy saving
lamps with a maximum power rating of 18W, otherwise there is a
risk of overheating!
www.degardo.de
DE
GB
FR
23

Publicité

Table des Matières
loading

Table des Matières