Setting Up Anynet; Scanning And Switching Between Anynet + Devices - Samsung LN-T4071F Instructions Du Propriétaire

Setting Up Anynet +

The following settings help set the Anynet + functions.
To use the Anynet + Function, Anynet + (HDMI-CEC) must be set to On
Press the Anynet + button.
1.
Press the ▲ or ▼ button to select "Setup", then press the ENTER button.
Press the ENTER button to select "Anynet + (HDMI-CEC)", then press the ENTER
2.
button.
, Press the ▲ or ▼ button to select "On", then press the ENTER button.
The Anynet + (HDMI-CEC) function is enabled.
If you select Off, Anynet + (HDMI-CEC) is disabled.
When the Anynet + (HDMI-CEC) function is disabled, all the Anynet + related
operations are deactivated.
Setting an Anynet + Device to turn Off Automatically when the TV is Turned Off
2. Press the ▲ or ▼ button to select Auto Turn Off, then press the ENTER button.
. Press the ▲ or ▼ button to select "On", then press the ENTER button.
The "Auto Turn Off" function is enabled.
If you select "Off", the "Auto Turn Off" function is canceled.
Press the ExIT button to exit.
The active source on the TV remote must be set to TV to use the Anynet + function.
If you set Auto Turn Off to On, connected external devices are also turned off when the
TV is turned off. If an external device is still recording, it may or may not turn off.

Scanning and Switching between Anynet + Devices

Press the Anynet + button.
1.
Anynet + devices connected to the TV are listed.
2. Press the ▲ or ▼ button to select to a particular device and press the ENTER button.
It is switched to the selected device.
.
If you cannot find a device you want, press the ▲ or ▼ button to select "Searching
Connections", then press the ENTER button.
The meassage "Configuring Anynet + connection..." is displayed.
When searching devices completes, the connected devices are listed in the Anynet +
menu.
Switching to the selected devices may take up to 2 minutes. You cannot cancel the
operation during the switching operation.
The time required to scan for devices is determined by the number of connected
devices.
When the device scan is complete, the number of devices found are not displayed.
Although the TV automatically scans devices when it is turned on using the POWER
button, devices connected when the TV is already on are not displayed in the device list.
In this case, select the Searching Connections menu to search devices.
If you have selected external input mode by pressing the SOURCE button, you cannot use the Anynet + function. Make sure to
switch to an Anynet + device by using the Anynet + button.
English - 78
Air 28
Recevier: On
Connect Recorder
Setup
Move Enter Exit
Anynet+ Setup
Anynet+ (HDMI-CEC) : Off
Off
Auto Turn Off : Off
On
Searching Connections
Move Enter
Anynet+ Setup
Anynet+ (HDMI-CEC) : On
Auto Turn Off : Off
Off
Searching Connections
On
Move Enter
Air 28
Recevier: On
Connect Recorder
Setup
Move Enter Exit
Anynet+ Setup
Anynet+ (HDMI-CEC) : On
Auto Turn Off : On
Searching Connections
Move Enter
Return
Return
►
►
►
Return