Hiyasu HS-9UIHN Mode D'emploi page 14

Remote control operation
LOCK function:
Use this function to lock and unlock the keyboard. The icon
Press the keys + and – simultaneously to lock or unlock.
Adjusting the air direction – SWING:
1- Press the Swing key
their position when the key is released.
2- Under the Swing mode, when the on/off status is changed to
status will switch off directly, if pressed again, in 2 sec. the change in the Swing status will also depend on the
rotation sequence determined beforehand.
Changing ºF to ºC:
To change between Fahrenheit and Centigrade, press the MODE and - key simultaneously, with the unit switched off.
New defrosting function:
What does this mean: once this function has been activated using the remote control, and the unit is in the defrosting
mode, if the unit is switched off using the control, the unit will not stop the defrosting until this function has finished; if
the programmed mode is changed using the control, the last programmed function will not run until the defrosting has
finished.
With this function activated: When the unit is switched off, press the Mode and X-FAN buttons simultaneously to
activate or deactivate this new function. If the unit is in Defrosting mode, H1 will appear on the remote control screen.
If we change to Heat mode, H1 will appear on the remote control screen and will flash for 5 seconds, if we press the
+/- buttons, H1 will disappear and the programmed temperature will be displayed.
When we switch on the remote control, this new defrosting function will be deactivated.
The remote control has 2 x AAA1.5V batteries
1- Remove the lid at the back of the control, by sliding it backwards
2- Remove the old batteries
3- Place two new batteries (AAA 1.5V type), taking into account
their polarity.
4- Replace the lid on the rear of the control
IMPORTANT
● Make sure that the batteries are replaced with two new batteries of the
same kind. Otherwise, the remote control made not work properly.
● Remove the batteries if the equipment is not going to be used for some
time.
● The remote control must be used within the action radius.
● Leave the control at a minimum distance of 1m from the TV or music
centre.
● Do not leave the control near electrical apparatuses or sources of heat.
● If the control does not work properly, remove the batteries and put them
back in again 30 seconds later. If it still does not work properly, change the
batteries.
continuously for more than 2 seconds, and the unit baffles will move and stop, maintaining
Arranging the batteries
indicates that it is locked.
, if this button is pressed again 2 sec. later, the
- 10 -
Battery cover
Diagram for changing
the batteries