Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
HOW TO USE
CONTROL PANEL FEATURES
A
POWER (ON/OFF) BUTTON
Press to turn the washer ON. Press again to
turn the washer OFF. Pressing the POWER
button during a cycle will cancel that cycle
and any load settings will be lost. The lid will
unlock after a brief pause.
NOTE:
• If there is any water remaining in the tub
after the washer shuts off, it will drain fol-
lowing 4-minutes delay. The washer can
be restarted any time before the drain be-
gins. However, once the water begins to
drain, all functions will be suspended until
the water has been completely drained
and the washer shuts off.
• When you press Power button, Normal
Course will be lighted on. But, to select
Normal Cycle, you need to turn the knob
to turn on the light of Normal Course and
activate the set options.
B
CYCLE SELECTOR KNOB
Turn this knob to select the desired cycle.
Once the desired cycle has been selected,
the standard presets will appear in the
display. These settings can be
using the cycle setting buttons any time
before starting the cycle.
NOTE: To protect your clothing, not all set-
tings are available on all cycle selections.
A
B
C
D
E
F
adjusted
C
E
START/PAUSE BUTTON
Press this button more than 0.4 seconds
hold to start the selected cycle. If the wash-
er is running, use this button to pause the
cycle without losing the current settings.
NOTE: If you do not press the START/
PAUSE button within 60 minutes of select-
ing a cycle, the washer automatically turns
OFF and all cycle settings are lost. And any
water remaining in the tub will be drained.
CYCLE MODIFIER BUTTONS
Use these buttons to adjust the settings for
the selected cycle. The setting lights above
the buttons illuminate to show the current
selection.
SPECIAL CYCLE AND OPTION BUTTONS
These buttons allow you to select special
cycles or options.
TIME AND STATUS DISPLAY
The display shows the cycle status and esti-
mated time remaining.
17
HOW TO USE
F
E
D
Publicité
Chapitres
Table des Matières
Dépannage
