Table des Matières
Publicité
INTRODUCTION
Technical data
Nominal voltage : 220-240V~ 50/60Hz
Nominal power : 650 Watt
Capacity : 4,5 liters
Shortt erm operation : 6 minutes
BEATER / WHISK / DOUGH HOOK
1. Place the mixing bowl into its holding device and turn the bowl until it locks into place.
2. In order to liftthe arm, push the rise butto n(2) down. The arm will now move upwards.
3. Mountt he required utensil by inserting the top into the output shaftand locking.
4. Now fill in your ingredients. Do not overfill the machine - the maximum quantity ofi ngredients is
1.2 kg.
5. Lower the arm using the rise button (2).
6. Insertt he mains plug into a properly installed 230 V/50 Hz safety power socket.
7. Switch the machine using the speed button to a speed between 1 and 6 (corresponding to the
mixture).
8. For pulse operation (kneading at shorti ntervals), turn the switch to the "PULSE" position. The
switch has to be held in this position according to the desired interval length.When the switch is
released it returns automatically to the "0" position.
Your accessories are equipped with a system for adjusting the height above the bottom oft he bowl
for optimum results. Depending on the nature oft he ingredients, the bowl with its cover can be used
to prepare up to 1,2 kg of dough.
e L
e v
s l
U
e s
y T
e p
f o
1-3
Dough hook
Heavy mixtures (e.g. bread or short pastry)
2-4
Beater
Medium-heavy mixtures (e.g. crepes or sponge
mixture)
5-6
Whisk
Light mixtures (e.g. cream, egg white, blancmange)
Pulse
Whisk
Whisk Interval (e.g. for mixing undersponge, egg white)
Be noted
Short operation time : with heavy mixtures, do not operate the machine for more than ten minutes,
and then allow itt o cool down for a further ten minutes.
9. After kneading/stirring turn the speed knob back to the "0" position as soon as the mixture has
formed a ball. Then remove the mains plug.
10. Press the rise button downwards and the arm will be raised.
11. The mixture can now be released with the help of a spatula and removed from the mixing bowl.
12. The mixing bowl can now be removed.
13. Clean the parts as described under "Cleaning" .
CLEANING
• Before cleaning remove the mains lead from the socket.
• Never immerse the housing with motor in water !
• Do not use any sharp or abrasive detergents.
Motor Housing
• Only a damp rinsing cloth should be used to clean the outside oft he housing.
30
ENGLISH
M
x i
u t
e r
DESCRIPTION
1. Bol en acier
5. Bouton de déverrouillage
2. Couvercle anti-éclaboussure
6. Bouton de vitesse
3. Arbre de sortie pour accessoire
7. Crochet pétrisseur
4. Bloc moteur
8. Batteur
9. Fouet
3
FRANÇAIS
Publicité
Table des Matières
