Insert Batteries - Revell Control ROTOBOT Manuel D'utilisation

HeLICoPter:
Stabiliser
Tail rotor
Landing skids
reMote CoNtroLLer:
GHz transmitter
Button for
motion control
Switch for
power ON/OFF
Actuating regulator
(up & down)
Charge status LED
1. Screw open
the cover and
remove it.
Caution: The battery has to cool off 10-15 minutes before charging and after each flight to prevent the flight battery from being damaged. Always monitor the charging procedure.
1. Switch off the helicopter and the remote
control unit.
2. Pull the charger cable out of the compartment
on the remote control (fig. 1).
3. Carefully insert the charging cable plug into
the charging socket on the helicopter (fig. 2).
The plug should fit into the charging socket
easily - DO NOT USE FORCE. If the plug is not
inserted correctly into the charging socket, the
helicopter may be damaged and there may be
a risk of injury.
4. Put the power switch on the remote control
unit to ON (fig. 3).
5. The POWER-ON-LED now flashes red and the
green charge status LED shows the charging
process (fig. 4).
6. The charging process is finished as soon as the
green charge status LED goes out.
7. Set the power switch to OFF after the charging
procedure and disconnect the charging cable
from the helicopter again.
After a charging time of approx.
40 minutes, the helicopter can fly approx.
6-8 minutes.
Helicopter and remote control unit
Contradirectional
rotor blades
Searchlight
Lighting on/off
"POWER ON" LED
Trimming regulator for
turning to the right/left
Forward/backward flight
Fly to the right/left
Turbo switch (please observe the
information in point 5)

Insert Batteries

Charging the Helicopter
fig. 1
You can also charge your helicopter with the enclosed USB cable:
a. Switch off the helicopter
b. Insert the charging cable plug carefully into the charging socket on the helicopter. The plug should fit into the
charging socket easily - DO NOT USE FORCE. If the plug is not inserted correctly into the charging socket, the
helicopter may be damaged and there may be a risk of injury.
c. Insert the USB connector into a free USB port.
d. The charging process is completed as soon as the USB connector goes out.
e. After charging, remove the USB plug from the USB port
2. Insert 6 x 1.5 V AA bat-
teries and observe the
polarity information as
shown in the battery
compartment.
Supercharging
bushing
ON/OFF switch
Initial position
Caution: This
regulator has to
point downwards
before switching on
the remote control
unit.
Battery
compartment cover
3. Close the battery
compartment cover
and screw it shut.
fig. 3
fig. 2 fig. 4
7