Chip Ejection; Service And Maintenance; Tool; Storage - Mafell ZH 245 Ec Notice D'emploi

again. Afterwards, it is possible to continue working
with reduced feed.
When working with a full planing width, the lever with
guide roller 7 is tilted downwards and tensioned with
the knurled knob 8. This provides the plane with a
lateral guide.
After planing, immediately switch off the machine by
releasing the switch and do not put down with running
planing shaft. When resetting the chip removal to 0,
the plane may be put down on a flat surface without
damaging the support, even if the blades are in an
unfavourable position.

5.5 Chip ejection

The carpenter's plane is designed such that during
planing with appropriate feed speed and fully utilised
planing width, an efficient chip ejection is ensured. In
the process, the chips are ejected to the side so that
the view onto the workpiece is not obstructed.
6

Service and maintenance

Danger
Pull the power plug during all
service work.
MAFELL machines are designed to be low in
maintenance.
The ball bearings used are greased for life. When the
machine has been in operation for a longer period of
time, we recommend to hand the machine in at an
authorised MAFELL customer service shop for
inspection.
Only use our special grease, order No. 049040 (1 kg
tin) for all greasing points.

6.1 Tool

The planing shaft, spacer blocks, blade carriers and
blades used on the machine should be regularly
deresinified as a clean tool improves the cutting
quality. Deresinification is carried out by placing the
spacer blocks, blade carriers and reversible blades
for 24 hours in petroleum or a commercial
deresinificaton agent.
Aluminium tools may only be
deresinified with solvents which do
not corrode the aluminium.

6.2 Storage

If the machine is not used for a longer period of time,
it has to be carefully cleaned. Spray bright metal parts
with a rust inhibitor.
-20-