Bimar HOTECH HC200L Notice D'instructions page 12

Fax +32 030 9904733
• Ensure that the power cable is correctly positioned and does not come into contact with hot parts
or sharp edges, nor become wound around the appliance itself, is not twisted and does not snag,
in order to prevent the appliance from falling. Make sure there's no risk of tripping, to prevent
people from accidentally tripping over it or being injured.
• Make sure that the air inlet and outlet are not blocked, to prevent fire hazards or possible
overheating; do not cover the device, nor use it for drying laundry.
• If there is a fault or the appliance is not working correctly, switch it off and have it checked by a
qualified professional. Repairs done by an unqualified person can be dangerous and cause the
guarantee to become void.
USER INSTRUCTIONS
Description
Model with electronic controls (type S602.EU)
The heater is equipped with the following adjustment devices:
- 0 / I switch (H) is located on the side and turns the machine on (I) or off (0)
- Panel with a display to view the functions and a keyboard with the following functions:
•
" " (A): activates the 750W heating element and puts the device in standby
•
" " (B): to set the three power settings: 750W/1250W/2000W
•
"+" (E) and "-" (F) to adjust the ambient temperature (between 05÷37°C), once the set
temperature has been reached, it activates the stand-by function: if the heating element is
activated by the lowering of the temperature.
•
•
" " (C) to select Celsius or Fahrenheit
•
" " (D), to start the fan
•
Timer " " (G), sets the time of operation, after which the unit will stop automatically. To set
the time, press "
15 hours). To deactivate the timer, press the button until the display time disappears. If the timer
is not activated, the device works until it is turned off.
•
Remote control (I), to select all the functions described above. The remote must be pointed at the
display, and before insert the battery (open the rear door and insert 2 batteries "AAA" with correct
polarity, close the door). With each change of function you will hear a beep.
Furthermore, the appliance is equipped with a switch that stops the rollover operation in case of a fall.
Reposition it vertically, you activate standby.
USE
Before each use, ensure that the appliance is in good working order, and that the power cable is not
damaged: if the cable is damaged, it must be replaced by the manufacturer or its service centre or by
someone with a similar qualification in order to prevent any risks. Ensure the air inlet and the heating
element are free of dust, lint, or anything similar: this improves the heater's performance, and prevents
overheating. Check for these conditions periodically.
Warning: before assembling, disassembling and cleaning the device, make sure it is disconnected
from the mains.
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Bimar
(Italy). The pages must be reproduced and folded in
order to obtain a booklet A5 (+/- 148.5 mm width x 210
mm height). When folding, make sure you keep the good
numbering when you turn the pages of the I/B. Don't
change the page numbering. Keep the language
integrity.
"repeatedly: each time it is pressed it selects (1 hour - 2 hours - 4 hours ...
12 39
/
Assembly page 12/39