Accessories; Applications - IDEAL Vol-Con XL Mode D'emploi

Levels (61-085 has LED indica-
tion only).
• Auto-Switching Voltage/
Continuity Technology (61-086
only)
• Independent solenoid and elec-
tronic circuitry design provides
back-up voltage indication for
added safety.
• Low Impedance Measuring
Device
• Replaceable Test Leads
• Shielded probe tips
• Ultrasonically welded and o-ring
sealed for added durability

Accessories:

• TL-82 Resistor-fused test leads
• C-90 Soft-sided carrying case
To Measure AC Voltage:
• Ensure that the plug for the test
leads is fully seated into the
banana jacks.
• Connect the tester in parallel with
the load or circuit.
• The tester indicates both the volt-
age type and the voltage level.
(See Tester Operation table)
To Measure DC Voltage:
• Ensure that the plug for the test
leads is fully seated into the
banana jacks.
- 5 -
• Connect the tester in parallel with
the load or circuit.
• The tester indicates the voltage
type, polarity, and the voltage level.
(See Tester Operation table)
To Test for Continuity: (61-086
only)
• Ensure that the plug for the test
leads is fully seated into the
banana jacks.
• De-Energize circuit before perform-
ing continuity test. Note, if voltage
is present in the circuit, the tester
automatically switches to voltage
indication mode.
• Test for continuity by connecting
the tester to the circuit.
• If circuit has 500kΩ or less
resistance, an audible indication
is heard and the Continuity LED
lights. (See Tester Operation
table)
• Reversing prods on the circuit
under test verifies continuity ver-
sus low voltage +DC.

Applications:

• Locating Blown Fuses
With power off: Place tester across
the suspected fuse to perform con-
- 6 -