Trouble Shooting - Albrecht AE 6491 NRC Mode D'emploi

9. Trouble shooting

Check at first the power supply and the fuse. A problem may be
caused through power supply, when no light or display appears
after switching on. If the unit works in a strange way, disconnect
the power supply cable (or take out the fuse from the holder),
while the radio remains switched on, wait some time (minimum
10 seconds), and then reconnect power cord again.
Another method is to make a "Factory Default"-reset. This reset
may also reset the country switching and the last channel used-
the radio just starts again like a brand new radio which had not
yet been connected.
• Switch the radio off
• Press AM/FM and MEM button and keep them pressed
during switching the radio on
• Release buttons
• The display shows rS and after a short time the radio starts
again. In most cases the functions of the radio will be
restored now.
• Check the microphone and antenna connector
If the reset procedure does not help, please contact our service
hotline.
49