Dc Power Connection 12 V / 24 V; Mounting Using Din Sleeve - Albrecht AE 6491 NRC Mode D'emploi

made from plastic or fiberglass or where a grounding is
not possible. Such antennas do only work on fiberglass or
plastic car body structures and do not work immediately on
metallic structures.
• Do not use any transmit function (e.g. PTT) before installing
the antenna

4.2. DC power connection 12 V / 24 V

The AE 6491 NRC version can operate at both 12 or 24 V voltage
systems. A switching is not necessary.

4.3. Mounting using DIN Sleeve

Before installing, confirm that this radio fits in the desired
mounting area and you have all the necessary kits to complete
the installation
• Remove the bracket if previously installed.
• Install DIN Sleeve into the opening in your dashboard, lip
facing out.
Push out the top and bottom tabs to hold the sleeve firmly
•
in place.
• Before inserting this radio in the sleeve, wire the cable from
the previously mounted antenna
• Connect the DC power leads. The RED wire goes to a
positive( + ) connection on your fuse block, while BLACK
33