ION Party Rocker Go Guide D'utilisation page 7

Using the Radio
1. Press the Radio button to turn on the FM radio. The LED above the button will light up
solid white. Party Rocker Go
2. Press and hold the Volume Up button to tune to the next strongest station signal. Press
and hold the Volume Down button to tune to the previous strongest station. If voice
prompts are enabled, you will hear the station's frequency number read aloud. For
example, upon tuning to 101.5 FM, you will hear the voice prompt: "One oh one point
five."
3. Use the ION Sound XP
App Control to learn how to download and use the app as a remote control for your Party
TM
Rocker Go speaker.
4. Press and then quickly release the Play/Pause button to cycle through the six station
presets. All presets are set to the factory default 87.5 FM.
Troubleshooting
If the unit is not charging: Make sure the micro-USB cable is properly connected to the
power input, the power adapter and the power outlet.
If the sound is distorted: Try lowering the volume control of your sound source.
If there is too much bass: Try adjusting the tone or EQ control on your sound source to lower
the bass level. This will allow you to play the music louder before clipping (distortion) occurs.
If you cannot connect your audio device to Party Rocker Go
•
Have your audio device (e.g., smartphone or tablet) and Party Rocker Go
together as possible while trying to connect. Make sure both the audio device and Party
TM
Rocker Go are unobstructed by walls, furniture, etc.
•
Reset the Bluetooth connection on Party Rocker Go
from any other audio device and restart the search process. If this does not work right
away, power off Party Rocker Go and then power it back on. See
with Party Rocker Go
•
Reset the Bluetooth connection on your audio device by turning Bluetooth off and back
on. You can find this under the Bluetooth menu in the Settings for your phone or other
audio device.
If this does not work, and you have connected to Party Rocker Go
TM
Rocker Go in the list of available or previously connected devices in your audio device's
Bluetooth menu, tap the "gear" or "i" icon located next to it and then select Unpair or
Forget. Turn Party Rocker Go
your available devices list.
Note: If Party Rocker Go
within range, you may need to repeat this process with that audio device to fully
disconnect.
If you experience audio dropouts while playing music from a Bluetooth device, this may
be happening because your unit is trying to link to another speaker. This can occur if you
power off a speaker that was linked to your unit or if you have just turned on your unit and it is
TM
in Stereo-Link mode. To stop the audio dropouts, exit Stereo-Link
pressing the Bluetooth button. Alternatively, you can wait for your unit to link to another
speaker if there is one within range.
TM
will pause Bluetooth audio but maintain the connection.
TM
app to save a station to one of six preset slots. See
TM
for more information.
TM
off and back on and try pairing again once it reappears in
TM
has been paired to another audio device recently that is still
TM
via Bluetooth:
TM
to disconnect Party Rocker Go
Bluetooth Connecting
TM
before, find Party
TM
mode by double-
Operation >
TM
as close
TM
7