ION Party Rocker Go Guide D'utilisation page 3

Charging & Battery Information
For the quickest charging time, power off Party Rocker Go
cable to connect the speaker to a USB power adapter (DC 5V 2A, not included) connected to
a power outlet, or your computer (powered on).
The LED (located above the Power Button) will appear solid red when charging, even if the
speaker is powered off. The LED will turn off when charging is complete. When the Party
TM
Rocker Go battery is low, the LED will flash red three times every 60 seconds; If voice
prompts are turned on, you will also hear "Battery Low".
If no audio is played through the Party Rocker Go
off automatically to conserve battery life.
Features
Front Panel
Power Button: Press and hold this button to turn Party Rocker Go
LED above the button will light up solid white when the speaker is powered on.
Double-press this button to disable or enable voice prompts.
Bluetooth
See Operation > Bluetooth Connecting with Party Rocker Go
connect a Bluetooth device.
Radio Button: Press this button to turn on the FM Radio.
See Operation > Using the Radio
Bass Boost Button: Press this button to enhance the speaker's bass frequency
response.
Lights Button: Press this button to cycle through lighting the bass radiator,
subwoofers, dome LEDs, and ground LEDs as listed below. Press and hold to switch
between Beat Sync and Color Cycle modes.
• Off
• Bass Radiator LED
• Bass Radiator LED + subwoofer LEDs
• Bass Radiator LED + subwoofer LEDs + dome LEDs + ground LEDs
Play/Pause Button: Press this button to play and pause Bluetooth audio.
Volume Up/Down Buttons: Press these buttons to adjust the speaker's volume.
Press and hold + or – to navigate Bluetooth tracks.
®
Button: Press and hold this button to disconnect a Bluetooth device.
TM
and use the included micro-USB
TM
speaker for 15 minutes, the unit will power
for more information.
TM
on and off. The
TM
to learn how to
3