Fitting; Preliminary Preparation And Checks - Honda UMK425E1 Manuel Du Propriétaire

FITTING

GRIPS AND HANDLES
The bike type handle [1] (U type)
or the loop handle [2] (L types)
must be installed on the
transmission tube [3].
[1]
[3]
CAUTION:
• U types: Position the handle
between the two arrows [4].
Fitting is to be performed using
the tools in the kit supplied with
the appliance.
[5] Spark plug wrench / Torx wrench
ATTACHMENT
PROTECTORS
Your brush cutter is supplied with
a guard.
Install the guard on the machine
with the four screws [8] and the
spacer [7] supplied with the Torx
wrench.
UTILIZATION WITH NYLON
LINE CUTTING HEAD
Fit the two sections [10] and [9]
and clamp them into place as
shown in the diagram. Screw the
3 screws and the washers by
using the torx wrench.
UTILIZATION WITH BLADE
Do not fit the lower section [10].
Never use the grass/weed trimmer without its debris shield.
Stones or other foreign objects thrown outward by the
wheeling cutting attachment (nylon-line, cutting head or
cutting blade) or contact with the wheeling cutting attachment
could cause personal injury or property damage.
4 EN
A1 A4
C11 D3
B3
SAFETY
[4]
[6] Hexagonal wrench
[7]
[8]
[9]
[10]
[9]
[10]
ASSEMBLING THE CUTTING
SYSTEM
CAUTION:
• Pay special attention when
fitting the spacer [13]. The
concave side must face the
transmission [15].
NYLON LINE CUTTING HEAD
With the spacer [13] already fitted
[3] on the transmission shaft, screw
on the nylon line cuttinghead. It is
[2]
tightened by turning
counterclockwise.
Use the hexagonal wrench [14] to immobilize the transmission so
that the nylon line cutting head is properly tightened.
3 - TOOTH BLADE
Place the grass-cutting disc [16]
between the spacers [13]
and [17] so that the grooves on
the spacers fit perfectly onto the
shaft.
Install the stabilizer [18]. Block
the rotation of the shaft with the
hexagonal wrench [14]. Securely
tighten the locknut [19] in the
counterclockwise direction with
the appropriate wrench.
FITTING AND
ADJUSTING THE
HARNESS
For operator safety and
comfort, it is important to
adjust the harness straps so
they can be worn comfortably
and so that the machine is
properly balanced in the
working position.
Machines are supplied with a
double harness [22].
Put on the harness and fasten it
with the quick fastener [23].
Adjust the straps with the
buckles [24] so that the machine
hangs at hip height.
PRELIMINARY PREPARATION
AND CHECKS
BALANCING THE MACHINE
Attach the brush cutter as
illustrated [1].
Once the machine is in place, it is
essential to check that it is
correctly balanced. This check
must be performed with the
cutting attachment fitted on the
appliance and with the fuel tank
half-full.
Adjust the length of the harness
so that the cutting attachment is
parallel to, and in contact with, the
ground.
B8
C11 D3
SAFETY
[14]
[15]
[13]
[14]
[13]
[16]
[17]
[18]
[19]
[22]
[24] [24]
[23]
[1]