Electrical Connection; Prior To First Use; Initial Operation - Graef WK300 Instructions D'utilisation

Never use the unit in the open, and store in a dry location.
●
The unit is not designed for installation in a wall or a built-in cupboard.
●
Do not set up the unit in a hot, wet or moist environment.
●
The socket has to be easily accessible so that the power cable can be removed easily in
●
case of emergency.

ELECTRICAL CONNECTION

For safe and fault-free operation of the unit, the following requirements have to be met during
the electrical connection:
Before connecting the unit, compare the connecting data (voltage and frequency) on the
●
type plate with those of your energy network. These details must correspond so that no dam-
age occurs to the unit. In case of uncertainty, contact a qualified electrician.
The socket has to be protected at least by a 10 amps circuit breaker.
●
Make sure that the power cable is not damaged and is not laid across hot surfaces or sharp
●
edges.
The connecting cable must not be stretched tightly.
●
The electric safety of the unit is ensured only when it is connected to a socket with protective
●
conductor installed correctly. Operation on a socket without protective conductor is forbid-
den. If in doubt, let the house installation check by a trained electrician. The manufacturer
shall not assume responsibility for damage which has been caused by absent or interrupted
protective conductor.

PRIOR TO FIRST USE

This unit brings water to the boil within a few minutes.
Fill the unit with clear cold water and re-boil it in order to clean the unit. Pour out the re-boiled
water.

INITIAL OPERATION

Take the base station and wind up the cable as far as possible.
●
Insert the plug into the socket.
●
Remove the lid.
●
Fill the electric kettle with a maximum of 1 litre of water. Do not exceed the
●
maximum fill-level marking. The water would bubble over when boiling.
Place the lid back on.
●
Place the electric kettle onto the base station and switch on the unit. The control light illumi-
●
nates blue.
IMPORTANT!
Make sure that the maximum fill mark is not exceeded. Fill the unit so that the water level is
between the minimum and the maximum fill-level marking. Burns / scalding may be caused
by effervescent water.
Once the brewing process is finished, the unit will automatically switch off. The control light
●
DE
EN
FR
NL
IT
ES
DK
SE
NO
PL
HU
UKR
21