PRO-POINT 8796534 Manuel D'utilisateur page 9

V1.1
WIRING
The pendant control has two sets of black and red wires. One set
connects to the battery terminals. The other set connects to the
winch terminals. The wiring is connected only when the winch is set
up for use.
1. Connect the red wire (Fig. 3-4) from the control (Fig. 3-6) to the
battery's (Fig. 3-1) positive (+) battery terminal. Secure with a nut.
2. Connect the black wire (Fig. 3-2) to the battery's (Fig. 3-1)
negative (-) terminal and secure with a nut.
3. Remove the nuts from the winch terminals (Fig 3-3).
4. Slide the
second black
wire connector
(Fig. 3-7) over
the negative (-)
terminal and
secure with a
nut.
5. Slide the red
wire connector
(Fig. 3-5) over
the winch's
positive (+)
terminal and
secure with a
nut.
OPERATION
WARNING! Do not release the clutch while the winch is pulling a
load. It may cause the load to shift or move unexpectedly and the
wire may snap with the unexpected stress. Either may cause death
or severe injury to the user or bystanders.
Visit www.princessauto.com for more information
2,000 LB 12V DC ELECTRIC WINCH
3-4
3-3
3-1
3-2
3-5
3-7
3-6
8796534
Fig. 3
9