PRO-POINT 8796534 Manuel D'utilisateur page 14

8796534
TROUBLESHOOTING
Visit a Princess Auto Ltd. location for a solution if the tool does not
function properly or parts are missing. If unable to do so, have a
qualified technician service the tool.
PROBLEM(S)
Motor
overheats.
Motor does not
turn on.
Motor runs, but
steel cable
drum does not
turn.
Motor runs
slowly or
without normal
power.
Motor runs in
one direction
only.
Motor is water
damaged.
14
2,000 LB 12V DC ELECTRIC WINCH
POSSIBLE CAUSE(S)
1. Incorrect power
cord.
2. Winch running time
too long.
1. Remote damaged.
2. Defective motor.
3. Internal damage or
wear.
Clutch not engaged.
1. Insufficient current
or voltage.
2. Incorrect power
cords.
1. Remote damaged.
2. Defective remote
button.
Submerged in water
or water from
pressure washing.
For technical questions call 1-800-665-8685
SUGGESTED SOLUTION(S)
1. Use only supplied power cord.
2. Allow winch to cool down
periodically.
1. Replace remote.
2. Check for voltage at armature
port with switch pressed. If
voltage is present, replace
motor.
3. Have technician service winch.
Move the clutch handle to the
engaged position. If problem
persists, a qualified technician
needs to check and repair.
1. Connect to appropriate power
supply.
2. Use only supplied power cords.
1. Repair or replace solenoid.
2. Replace remote.
Allow to drain and dry
thoroughly, then run the motor
without load in short bursts to
dry the windings.
V1.1