Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
8796534
1.
Choose a location on the vehicle that can withstand the stress of
the maximum weight capacity (see Specifications). You may install
a steel reinforcement plate or additional bracing to strength the
location.
2.
Make sure there is adequate room for the winch and a
flat surface for it to sit on. Verify the structure where the bolts
will go contains no hidden wiring or components. Relocate
either the winch or the wiring/components if there is overlap.
3.
Mark the holes along the center using the winch's base as a
template. Reach through the front or back opening to make the
marks.
4.
Drill each hole with a 5/16 in. drill bit to accommodate the bolts.
5.
Position the winch to align the bolt holes on the bottom with the
pre-drilled holes.
6.
Insert each bolt through the winch bottom and structure. Access
the bolt holes through the front or rear of the winch.
7.
Slide a washer, lock washer and nut over each bolt end. Tighten
the nuts.
8
2,000 LB 12V DC ELECTRIC WINCH
For technical questions call 1-800-665-8685
V1.1
Fig. 2
Publicité
Table des Matières
