1 Proper use
With this remote control, you can operate Metz TV sets and AV
devices connected to the TV set in their basic functions.
2 Safety instructions
Do not hold the remote control directly in front of your eyes and
press a key! Infrared light!
The batteries that are used must not be exposed to
excessive heat such as sunshine, fire or the like!
• No rechargeable batteries may be inserted in the battery
compartment of the remote control. Only two
LR03/AM4/AAA 1.5 V micro batteries may be used.
3 The remote control
The remote control sends commands to the TV set by means of an
infrared signal. You must point it towards the TV set when using it.
Note that the remote control may interfere with the operation of
other devices which use infrared signals (such as infrared head-
phones).
Sunlight falling directly on the TV set may interfere with the opera-
tion of the remote control, since the TV set cannot detect the
infrared signals from the remote control under these conditions. The
TV set must be switched on with the main power switch before it can
be controlled with the remote control.
The manufacturers of various AV devices use different frequencies
for the infrared light of their remote control.
Almost all the manufacturers' frequencies have been stored in this
remote control.
To activate one of these frequencies, you must enter a four digit
code according to the following device code.
This remote control can direct various external AV devices in their
basic functions.
This remote control does not replace the system remote
control of your AV device.
DVD
The button
can be programmed for the basic operation of
DVD players or DVD recorders.
STB
The button
can be programmed for the basic operation of set
top boxes (receivers, tuners, cable receivers, etc).
AUX
The button
can be programmed for the basic operation of
audio amplifiers.
Under the factory settings, the
buttons are deactivated..
3.1 Activating the buttons
To activate the individual buttons, proceed as follows (using the
DVD
example of the
button):
DVD
F3
• Press the
and
three seconds.
TV
STB
DVD
The
,
,
DVD
times. The button
Controls:
DVD
If you press the
button, this illuminates and you can then
programme your DVD or Blu-ray player.
13
STB
DVD
,
, and
buttons at the same time and hold for
AUX
and
buttons flash slowly three
is activated.
AUX