Uline H-5947 Manuel D'instructions page 5

16. Using pliers, attach a spring to the adjustment fork
and 54mm bolt. (See Figure 16)
NOTE: Repeat for the other side.
Figure 16
Spring
Adjustment
Fork
54mm
Bolt
17. Secure the back to the legs with two 52mm bolts
and locknuts. (See Figures 17-19)
NOTE: Align holes per Figure 18.
Figure 17
Figure 18
Holes
PAGE 5 OF 18
ASSEMBLY CONTINUED
Spring
Back
18. Loosen the locknuts just enough to allow you to
rotate the handle. Tighten only by hand at this point.
(See Figure 19)
NOTE: Repeat for the other side.
Figure 19
Locknuts
19. Adjust the back until it is level. Tighten the hardware
from the previous step with 8 x 10mm wrench.
(See Figure 20)
NOTE: Repeat for other side.
Figure 20
52mm Bolts
0721 IH-5947