Timer On/Off; Setting The Timer; 6 Rapid Preheat (On Some Models); 6 Convection Auto Conversion (On Some Models) - LG LRE6387ST Manuel Du Propriétaire

16
features

TIMER ON/OFF

The TIMER ON/OFF serves as an extra timer in the kitchen
that will sound when the set time has run out. It does not
start or stop cooking.
The TIMER ON/OFF feature can be used during any of the
oven control functions.

Setting the Timer

1. To set hours and minutes:
Press the TIMER ON/OFF button once.
To set minutes and seconds:
Press the TIMER ON/OFF button twice.
2. Use the number buttons to set the timer.
For example, to set the timer for five minutes: Press
the TIMER ON/OFF button once and then press the
5 button.
3. Press Timer or START button to start the timer. The
time will count down and the time will show in the
display.
note
If TIMER ON/OFF or START button is not
pressed, the timer will return to the time of
day.
4. When the set time has run out, End will appear in
the display. The indicator tones will sound every 15
seconds until TIMER ON/OFF is pressed.
To Cancel the Timer
1. Press the TIMER ON/OFF button once. The display
will return to the time of day.
note
If the remaining time is not shown in the display,
recall the remaining time by pressing the TIMER
ON/OFF button.
RAPId PREhEAT (ON SOME
MOdELS)
The Rapid Preheat feature can preheat your oven up to
20% faster than the normal preheat function.
Setting Rapid Preheat
1. Press the cook function button (ex. the BAKE
button).
2. Using the number buttons, enter the cook time.
3. Press the START button
4. Press the RAPID PREHEAT button.
CONvECTION AUTO CONvERSION
(ON SOME MOdELS)
When cooking using convection cycle (Conv. bake and
roast), the oven temperature is automatically reduced by
25°F. The display will show the changed temperature.
This feature is called "AUTO CONVERSION". Your range
comes with this feature "ENABLED".
To DISABLE the auto conversion feature, follow below .
1. Press the SETTING button one time. "AUTO" will
appear in the display.
2. Press the 1 button to ENABLE or press the 2 button
to DISABLE.
3. Press the START button to accept the change.