Honeywell HHF360 Serie Manuel D'instructions page 2

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

10. CAUTION – THIS APPLIANCE HAS A
POLARIZED PLUG (ONE BLADE IS WIDER
THAN THE OTHER). TO REDUCE THE RISK
OF SHOCK, THIS PLUG IS INTENDED TO
FIT ONLY ONE WAY IN A POLARIZED
OUTLET. IF THE PLUG DOES NOT FIT
SECURELY IN THE OUTLET, REVERSE
THE PLUG. IF IT STILL DOES NOT FIT,
CONTACT A QUALIFIED ELECTRICIAN. DO
NOT ATTEMPT TO DEFEAT THIS SAFETY
FEATURE.
11. Warning – It is normal for the plug to feel
warm to the touch; however, a loose fit
between the AC outlet (receptacle) and plug
may cause overheating and distortion of
the plug. contact a qualified electrician to
replace loose or worn outlet.
12. Warning – To disconnect the heater, first
turn off the product, then grip the plug body
and pull it from the wall outlet. Never pull by
the cord.
13. Warning – Do not insert or allow foreign
objects to enter any ventilation or exhaust
opening as this may cause an electric shock
or fire, or damage the heater.
14. Warning – To prevent a possible fire, do not
block air intakes or exhaust in any manner.
Do not use on soft surfaces, like a bed, or
where openings may become blocked.
15. Warning – A heater has hot and arcing or
sparking parts inside. Do not use it in areas
where gasoline, paint or flammable liquids
are used or stored.
16. Warning – Use this heater only as
described in this manual. Any other
use not recommended by the
manufacturer may cause fire,
electric shock, or injury to persons.
17. Warning – Always plug heater directly into
a wall outlet/receptacle. Never use with an
extension cord or relocatable power tap
(outlet/power strip).
18. Warning – Never tamper with this product
or attempt to fix it. Any tampering with, or
modification of this product can result in
serious injury, death, or fire. Risk of electric
shock. Do not open. No user serviceable
parts inside.
19. Warning – Do not remove product labels
that contain warnings or safety instruction.
20. Caution – The output of this heater may
vary and its temperature may become
intense enough to burn exposed skin. Use
of this heater is not recommended for
persons with reduced sensitivity to heat or
an inability to react to avoid burns.
21. Caution – Before cleaning, or storage, or
when not in use, turn the product's controls
to the OFF position and unplug the heater
from the electrical outlet and allow to cool.
22. Caution – Place the heater on a firm, level,
open surface free from obstructions and
at least 3 feet (0.9 m) away from any
combustible materials. DO NOT use on an
unstable surface such as bedding or deep
carpeting. Be sure the heater is not in a
position where it may be tripped over by
small children or pets. The heater's rubber
feet will hold it firmly in position.
23. Caution – If your home has aluminum
wiring have a licensed electrician check
your receptacle's connections. When
using a 1500 watt heater, aluminum wire
connections can cause a safety issue.
SAVE THESE
24.
INSTRUCTIONS
SET-UP
• Place the heater on a firm, level, open surface free from obstructions and at least 3 feet (0.9m)
away from any wall or any combustible material. DO NOT use on an unstable surface such as
bedding or deep carpeting.
BE SURE THE HEATER IS NOT IN A POSITION WHERE IT MAY BE TRIPPED OVER BY
CHILDREN OR PETS.
MOVING THE HEATER
• Turn off the heater.
• Allow it to cool for ten minutes.
• Unplug heater and move. Heaters are equipped with a Cool Touch Handle for your convenience.
OPERATION
• NOTE: The 360° Surround Heat
Heater requires no assembly.
®
• NOTE: NEVER LEAVE AN OPERATING UNIT UNATTENDED
• The 360° Surround Heat
Heater is designed to disperse heat in a 360° range.
®
Model HHF360 Series – Manual Surround Heat
o
• With the Power Knob in the OFF (
) position, plug the heater into a polarized 120V outlet.
DO NOT FORCE THE POLARIZED PLUG INTO THE OUTLET; it will only fit one way.
• The Power Knob is equipped with two (2) settings, Low and
High. The Low setting uses 750 watts of power and the High
setting uses 1500 watts of power. You can select the proper
setting to accommodate your comfort level with the Power
Knob. When you choose any setting the red Power Light will
come on. Because the Low setting does not require as much
electricity to operate, it is more energy efficient and may be a
better option if you are concerned about the amperage draw
on a circuit when the heater is on the High setting.
• Turn the Thermostat Control fully clockwise to the highest
setting.
• When the room reaches a comfortable temperature, slowly turn the Thermostat Control
counter-clockwise until the heating element goes off (the red Power Light will not be shut off).
This is the point at which the Thermostat setting equals the room temperature. At this setting,
the Thermostat will automatically turn the heater on and off to maintain the selected temperature.
o
• Turn the Power Knob to OFF (
) and unplug the heater when you are finished using it.
Heater Operation
®
Heat Setting
Power
Light
Thermostat Control

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Hhf370 serie

Table des Matières