Porter Cable PC160JT Manuel D'instructions page 9

FENCE ADJUSTMENTS
The fence can be moved across the table and can be tilted up
to 45 degrees, as follows:
1. To move the fence across the table, loosen lock lever (A)
Fig. 25, slide the fence to the desired position on the table
and tighten lever (A).
NOTE: Lock lever (A) is spring loaded and can be repositioned
by pulling up on the lever and repositioning it on the nut located
underneath the lever.
2. To tilt the fence, loosen lever (B) Fig. 25, and tilt the fence
to the desired angle. Then tighten lever (B).
NOTE: Lever (B) is spring loaded and can be repositioned by
pulling out on the lever and repositioning it on the nut located
un der neath the lever.
3. The fence features adjustable positive stops at the most
used fence positions of 90 degrees and 45 degrees to the
right. To check and adjust the positive stops, proceed as
follows:
4. Place a square (C) Fig. 26, on the table with one end of the
square against the fence as shown. Adjust the fence until it
is exactly 90 degrees to the table.
5. Using supplied hex wrench, turn set screw (D) Fig. 27 until
it contacts stop (E).
6. Using a square (C) Fig. 28, tilt the table to the 45 degree
position and make sure the fence is 45 degrees to the
table. Adjust the fence if necessary.
7. Using supplied hex wrench, turn set screw (H) Fig. 29, until
it contacts stop (G).
8. These positive stops enable you to rapidly position the
table to the 90 and 45 degree settings.
Make sure the fence is in level contact with
the surface of the outfeed table.
28
25
26
27
29
C
9
B
C
D
E
H
g
A