Troubleshooting - Husqvarna AUTOMOWER 105 Manuel D'utilisation

6.1 Troubleshooting

In case of malfunction, a message will appear on the display. For more detailed information on messages, see the
complete Operator's manual on Husqvarna's website (www.husqvarna.com. If the same message appears often or if
you still cannot find the reason for the fault, contact your dealer.
Breaks in the loop wire are usually the result of unintentional physical damage to the wire such as when gardening
with a shovel. Breaks can also be due to the wire being stretched excessively during installation. A wire break can be
located by gradually halving the distance of the loop where the break may have occurred until there is only a very
short section of the wire left. See the complete Operator's manual on Husqvarna's website (
6.1.1 Indicator lamp in the charging station
For a fully functional installation, the indicator lamp in the charging station must emit a solid or flashing green light. If
something else appears, follow the troubleshooting guide below.
There is more help on www.husqvarna.com. If you still need help, please contact your local Husqvarna
representative.
Light Cause
Solid green light
Good signals
Green flashing light
The signals are good and
vated.
Blue flashing light
The boundary loop is not connected to the
charging station.
Break in the boundary loop.
Red flashing light
Interruption in the charging station's antenna. Contact your local Husqvarna representative.
Solid red light
Fault in the circuit board or incorrect power
supply in the charging station. The fault
should be rectified by an authorized service
technician.
247 - 005 - 01.09.2017
6 Troubleshooting
ECO mode is acti-
www.husqvarna.com ).
Action
No action required
No action required. For more information on
ECO mode , see Complete Operator's Manual
on page 3 .
Check that the boundary wire connectors are
fitted properly to the charging station. See
Complete Operator's Manual on page 3 .
Find out where the break is. Replace the
damaged section of the loop with a new loop
wire and splice using an original coupler.
Contact your local Husqvarna representative.
Troubleshooting - 17